Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Display shows !WARNING 01
Display shows !WARNING 02.
Display shows !WARNING 03.
Display shows !WARNING 43.
Display shows !WARNING 14.
Display shows Alert 1: low
voltage.
Display shows Alert 2: lid
open > 3 minutes.
12 Disposal
NOTICE! Damage hazard
The insulation of the cooling device contains flammable cyclopentane and requires special disposal pro-
cedures. Deliver the cooling device at the end of its life-cycle to an appropriate recycling center.
Recycling products with batteries, rechargeable batteries and light sources: Remove any batteries,
rechargeable batteries, and light sources before recycling the product. Return defective or used batteries
to your retailer or dispose of them at collection points. Do not dispose of any batteries, rechargeable bat-
teries, and light sources with general household waste. If you wish to finally dispose of the product, ask
your local recycling center or specialist dealer for details about how to do this in accordance with the ap-
plicable disposal regulations. The product can be disposed free of charge.
Possible cause
NTC open circuit
NTC short circuit.
Communication error
Communication error (local)
Inner fan fault
Low voltage
Abnormally high voltage >17.3 V due
to
• Incorrect DC supply voltage
specification
• Faulty supply voltage
• Internal fault
Door is open for longer than 3 min.
Suggested remedy
Contact the manufacture's
support documents.domet-
ic.com/contact.
Contact the manufacture's
support documents.domet-
ic.com/contact.
Contact the manufacture's
support documents.domet-
ic.com/contact.
Contact the manufacture's
support documents.domet-
ic.com/contact.
Contact the manufacture's
support documents.domet-
ic.com/contact.
Check the battery voltage and
charge the battery.
Ensure the DC supply voltage
specification matches the prod-
uct data plate.
Check the DC voltage supply
and replace it if it is faulty.
Ensure DC supply voltage speci-
fication matches the product da-
ta plate
Check DC voltage supply and
repair or replace if faulty
Contact an authorized service
agent.
1.
Ensure the door is locked tightly.
2.
If door is locked tightly and Alert
is still displayed, contact the
manufacture's support
ments.dometic.com/contact.
EN
docu
19
Publicidad
