Thermador PRO HARMONY PA30GLBH Manual De Instalación página 2

High Shelf Assembly
NOTE:
If a Backsplash is to be used in addition to a backguard,
install the Backsplash first and the backguard second
before sliding range into place.
1. Remove protective plastic.
2. Slide the shelf onto the backguard panel.
3. Install the included stainless screws along the topside
of shelf and into the back of the shelf.
4. Begin with Backguard Installation.
Backguard Installation
1. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim.
English 2
All manuals and user guides at all-guides.com
2. Remove the (4) drill point screws securing the trim to
3. Align the back panel of the new accessory with the
4. Make sure the backguard's front face is outside the
5. Re-install screws removed in Steps 1 and 2.
the side panels, and the (2) to (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove.
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
flange on the front side of the range.