auna Connect 100 MKII Manual De Instrucciones página 57

SETTINGS
Setting an alarm
1. Press and hold the MENU/INFO button to view the main menu.
2. Turn and press the NAVIGATE dial to select 'Alarms'
3. Turn and press the NAVIGATE dial to select 'Alarm 1' or 'Alarm 2'.
4. Turn the NAVIGATE dial to scroll through each alarm setting. If you want
to change a setting, press the NAVIGATE dial. You can set the following
alarm options:
Enable Turn and press the NAVIGATE dial to choose when
you want the alarm to repeat. The available options
are 'Off ','Daily', 'Once', 'Weekends' or 'Weekdays'.
Time Turn and press the NAVIGATE dial to adjust the
hour of the alarm. Note: If you have set to use the
12 hour time format, make sure that you select the
'AM' or 'PM' version of the hour before pressing the
NAVIGATE dial. Repeat to set the minutes of the
alarm.
Mode Turn and press the NAVIGATE dial to choose between
'Buzz', 'Internet radio', 'DAB', 'FM'.
Volume Turn and press the NAVIGATE dial to set the volume
when the alarm sounds.
Save Turn and press the NAVIGATE dial to save the alarm.
Sleep setting
This function allows you to program the unit to turn to standby mode by
itself after a set period of time.
1. To activate the sleep function, press the SLEEP button repeatedly. The
time will change in the below sequence on every press: Sleep off-15mins
- 30mins - 45mins - 60mins
2. When your desired sleep time appears in the display, stop pressing
the button and the sleep function will be activated in two seconds.
Sleep will show on the display. Also the time remaining until switch o is
displayed next to the symbol in the display.
3. When the sleep timer counts down to zero, the unit will turn to standby
mode. To turn the sleep function o ff while the sleep timer is still counting
down, press the SLEEP button repeatedly to select "SLEEP OFF". Sleep
will disappear from the display.
4. Press the SLEEP button once to show the sleep timer status on the
EN
57