LORGAR LRG-GP510 Manual De Instrucciones página 8

2. Switching on the gamepad and connecting it to devices.
Wireless
Android According to scheme A (see
page 3)
iOS According to scheme C (see
page 4)
PC According to scheme D (see
page 4)
Nintend Home menu of the
o Switch console → "Controllers" →
"Change Grip and Order".
Next – according to scheme
F (see page 5)
PS3 According to scheme H (see
page 5)
The LED indicators ⑧ will light up if the connection is successful.
3. Switching off. Press and hold the Home button ④ for 5 seconds. A gamepad
connected via BT turns off automatically after 5 minutes of inactivity. A gamepad
connected via USB cable does not automatically disconnect when idle.
Currently, the Android and iOS operating systems do not support the vibration function on
the gamepad.
When gamepad is connected to the Nintendo Switch, the buttons change their function
(see table 1 on page 6). Up to 8 gamepads can be connected to the Nintendo Switch. The
combination of LED indicators ⑧ in multiplayer game corresponds to the player's number
(see table 2 on page 6).
When gamepad is connected to the PS3, the buttons change their function (see table 3
on page 6). Up to 7 gamepads can be connected to the PS3. The combination of LEDs ⑧
in multiplayer game corresponds to the player's number (see table 4 on page 6).
Button R3. Pressing the right joystick ⑨ in the rightmost position corresponds to
pressing the R3 button.
L3 button. Pressing the left joystick ① in the leftmost position corresponds to pressing
the L3 button.
Turbo button ③. The Turbo mode is used for automatic continuous repetition of the
command.
Press and hold the desired button (A, B, X, Y ⑥, LB, RB ⑬, LT, RT ⑩) and press the
Turbo button ③ to assign the turbo mode. A short vibration signal is emitted when the
Turbo mode is activated. The backlight of the right joystick ⑨ flashes red all the time the
turbo mode is on.
To cancel Turbo mode, press and hold the button for which it was selected and press the
Turbo button ③. The backlight of the right joystick ⑨ lights blue when Turbo mode is off.
When gamepad is connected to the Nintendo Switch, the Turbo button ③ can be used
as a screenshot button, to view video duration, to switch Turbo mode functions. To switch
the Turbo mode functions, press and hold the R3 button and then press Turbo ③.
The Home button ④ is used to exit the game, go to the home page, and turn off the gamepad.
The reset button ⑮ is designed to reboot the gamepad. Use a thin object (special pin,
paper clip, etc.) to press it.
8
DEVICE CONNECTION FEATURES
BUTTON FUNCTIONS
Wired
According to scheme B (see page 3)
Not supported
According to scheme E (see page 4)
Home menu of the console → "System
Settings" → "Controllers and
Sensors" → "Pro Controller Wired
Communication". Next – according to
scheme G (see page 5)
Not supported