Waste Tray; Troubleshooting - Buffalo CD474 Manual De Instrucciones

UK
Scraping
After each use, scrape the appliance with a scraper/grill stone/copper brush or flexible spatula to remove
excess fat and food. A waste tray is provided for the scrapings if necessary
If there is an accumulation of burned fat or food, the cooking surface should be thoroughly scoured and
re-seasoned
NOTE: IT IS VITAL THAT THE COOKING SURFACE IS RE-SEASONED AFTER SCOURING
WARNING: DO NOT USE STEEL WOOL AS IT MAY LEAVE SHARDS THAT COULD CONTAMINATE
FOOD

Waste tray

This appliance feature a waste tray to collect any liquid or fats that run off during cooking
At least once a day, remove and empty the waste tray before washing with warm, soapy water. Do not
allow the tray to overfill, or excess grease will run out of the overflow hole at the front of the tray
WARNING: DO NOT REMOVE THE TRAY DURING OR IMMEDIATELY AFTER USE AS THE CONTENTS
WILL BE HOT
Trouble Shooting
If your BUFFALO product develops a fault, please check the following table before making a call to your
BUFFALO agent.
Fault
The product is not working
Product does reach set
temperature
The light only comes on
when the power is going to
the element so the product
can be hot when this light
goes out.
4
Probable Cause
The product is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply problem
Internal wiring fault
Faulty thermostat
Faulty element
Bulb has failed
Action Required
Check the unit is plugged in correctly
and switched on
Call your BUFFALO agent or qualified
electrical technician
Replace the plug fuse
Check power supply
Call your BUFFALO agent or qualified
electrical technician
Call your BUFFALO agent or qualified
electrical technician
Call your BUFFALO agent or qualified
electrical technician
Call your BUFFALO agent or qualified
electrical technician