Publicidad
Operation
• Press firmly the screw bit against the material to be
screwed until the depth stop sits against the material and
the screwing insert is released.
• To loosen screws, set the rotation direction selector
button in the unscrewing position and turn the depth
control knob to the maximum.
Cleaning and care
• To guarantee adequate motor cooling, always keep slots
clean and free of obstructions.
• Regularly inspect all the mounting screws. Double-check
they are properly tighten. If any screw is loose tighten
immediately.
Service
• Service should only be made in a
Authorized Service Center. Service and maintenance
performed by non-qualified people may be dangerous and
lead to personal injuries. It also makes the product
Warranty void.
8
ENGLISH
Start Up
Maintenance
Lubrication
• We recommend lubricating the tool transmission every
carbon brush change in a
Service Center.
Carbon brush replacement
• Carbon brushes should be checked periodically.
• When one or both carbon brushes show signs of wear go
to a
Authorized Service center to have
both carbon brushes replaced. When replaced, see if the
new carbon brushes move freely in the carbon brush
housing. Ask to turn on the tool during five minutes to
make the contact in the carbon brushes and the commuter
even.
• Use only original
brushes, designed specifically with the right strength and
electric resistance for each type of motor. Carbon brushes
with different specifications may damage the motor.
• When replacing carbon brushes, always change both.
Authorized
spare carbon
Publicidad
