Publicidad
Safety standards for
power screwdrivers
General standards
CAUTION
• This tool is designed to operate with
screws. IT IS NOT A DRILL.
• Do not try to modify in any way the tool or its
accessories.
Select de adequate bit
CAUTION
• Use only screwdriver bits
recommended by
• Keep the screwdriver bits in good working condition. It
reduces load on the tool and increases its useful life.
.
Before operating the screwdriver
• Take your time to assess the job to be done.
Double-check all the necessary caution measures are being
observed before starting to work.
WARNING
• Adjust correctly the bit to the bit
holder.
DANGER
• Before fitting screws into a wall, floor or
ceiling verify there are not embedded objects like cabling,
power lines or pipes.
• Verify the switch is in the OFF position (see page 7 start
up and operation control section) before plugging in the
tool. Otherwise the tool might unexpectedly star running
causing severe injuries.
• Turn off and disconnect the tool before
CAUTION
reversing the bit rotation. Do likewise before installing or
replacing bits.
When operating the screwdriver
• Hold the tool by the insulated surfaces designed for this
purpose. The holder could wiring or with its own power
cord. Making contact with a power cord causes the tool
metal parts get electrified and may result in electric shock
to the user.
• Do not subject the tool to excessive efforts.
• Refrain from setting the tool immediately after using
where there are particles and/or dust. Debris may be
absorbed into the tool mechanism and be damaged.
• Hold the power tool by the gripping surfaces when
making an option where the fastener can make contact
with hidden wires or its own power cord.
Fasteners that come into contact with an energized cable
can turn the metal parts of the power tool into living parts
and, as a result, cause an electric shock to the operator.
ENGLISH
5
Publicidad
