Publicidad
Mounting Methods
Direct Mount / Single Point Remote Installation
Multi-Point Installation
22
any multi-point installations and for all 480ml installations.
EN
Single Point Installation (Alkaline, Lithium Battery)
Direct Mount or Remote Installation using Extension Tube
For applications not allowing any direct mounts, remotely mount the unit using
appropriate accessories and keep the distance from the lube point as short as
possible. For remote installation using a tube, use a Ø6 (1/4") tube pre-filled with the
same or compatible grease as the grease contained in the unit.
Multi-Point Installation (Lithium Battery Only)
Multi-Point Remote Installation using Progressive Divider Block (2~8 points)
Ensure the break-off pressure is below the average operating pressure of 30bar (435psi).
▶ For more information, please refer to the distributor user manual.
(Reference: Website > Service Menu > Technical Information)
CN
单点润滑
直接安装或利用连接管远程安装
直接安装或远程安装时请用相应配件进行安装, 连接管长度请保持最
短。使用连接管进行远程安装时, 请预填充与加脂器同类的油脂并使
用外径6mm以上连接管。
多点润滑
使用分配器( 2~8口 )多点/远程安装
所有管路背压( 包括分配器 )需 30bar
▶
详细内容请查看分配器说明书。
NOTE. Lithium battery pack is required for
(435psi)以下才可正常使用。
( 网站 > 服务 > 技术信息 )
Publicidad
