Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: This unit is intended for water dispensing only. Do NOT use
other liquids. Do NOT use for other purposes. Warranty is void if used
with any other liquids such as coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3
or 5 gallon capacity. Do NOT use alternative bottles.
Initial Set Up
To avoid damage to the compressor, allow the unit to sit upright for at least
to operation. NOTE: Make sure that switches are OFF. The Hot
4 hours prior
and Cold switches are located in the back of the water cooler.
1.
Check the backside of the machine to make sure the drainage hole is fully plugged.
2.
Remove the tamper seal from bottle cap. Do not remove plastic cap.
3.
Lift the bottle safely (see assembly above) and place
bottle until it's secure and bottle is seated.
4.
Push the water dispenser until water comes out. Do not
plug in the machine until water comes out.
5.
After water comes out of the hot water spigot, plug the cord into a properly grounded
wall outlet. WARNING: Always make sure that the cord is away from a water source.
Dispensing Cold Water
1.
After setup, turn on the cooling switch. The green LED indicator light will turn on,
signaling that the machine has begun cooling water. It will take up to 6 hours for
the water to reach its maximum cooling temperature. When the water has reached
its maximum cooling temperature, the green LED indicator light will turn off.
2.
Place bottle, glass, or pitcher below the cold water tap.
3.
Press the cold water button downward to start dispensing water.
4.
Release the button once the desired fill
level is achieved.
Dispensing Hot Water
1.
After setup, turn on the heating switch. The
red LED indicator light will turn on, signaling
the machine head begun heating water.
will not take long
reach maximum hottest temperature. When it reaches hottest temperature, the red
light will turn off. NOTE: For safety, there is a lock on the dispensing button.
2.
Place bottle, glass, pitcher, pot below the hot water tap.
3.
Release child-safety lock by sliding the red button and press the hot water
button downward at the same time to start dispensing water.
4.
Release the button once desired fill level is achieved.
NOTE: Be careful when dispensing hot water as temperature can reach 203°F.
Replacing An Empty Bottle
that
It
to
8
Publicidad
