Publicidad
Idiomas disponibles
Idiomas disponibles
Replace the bottle as soon as you notice that it is empty.
1.
Lift the bottle straight up to disengage it from the bottle probe.
2.
Remove the tamper seal from the bottle cap of the NEW
bottle. DO NOT remove the plastic cap.
3.
Lift the bottle and insert it (assembly directions above). Apply slight pressure
until the plug inside the cap pushes in and the bottle is secure
Refrigerator
Please follow all initial setup steps before plugging in machine to use refrigerator.
After being powering on, it will take up to 12 hours for the refrigerator to
reach its cooling temperature set point. The temperature will range from 50°F
to 57°F. NOTE: It is NOT recommended to use the refrigerator for storing
perishable food items or medicines that need to be refrigerated.
HELPFUL TIPS
DISPENSER IS NOT WORKING
•
Make sure that the power cord is properly connected to a working outlet.
WATER IS LEAKING
•
Replace water bottle. Most common cause is a cracked bottle.
NO WATER IS COMING OUT
•
Make sure bottle is not empty. If so, replace it.
•
Make sure that you fully press the water control buttons.
WATER DISPENSER IS NOT COLD
•
Make sure cold switch is ON. Switch is located in the back of the water cooler.
•
It can take up to six hours after setup to dispense coldest water.
•
Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to flow on all four sides of dispenser.
WATER DISPENSER IS NOT HOT
•
Make sure cold switch is ON. Switch is located in the back of the water cooler.
•
It can take up to 30 minutes after setup to dispense hottest water. Each
time hot water is dispensed, it needs time to heat up again.
•
Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to flow on all four sides of dispenser.
DISPENSER IS NOISY
•
Make sure that the dispenser is positioned on a level surface.
•
As each cycle ends, you may here gurgling sounds. This is normal.
CLEANING & MAINTENANCE
General Cleaning
9
Publicidad
