Publicidad
Idiomas disponibles
Idiomas disponibles
Use EXTREME CAUTION when handling the appliance. When taking out of package,
it is recommended to lay the box safely on its side. The COLD & HOT TOP LOADING
WATER DISPENSER WITH REFRIGERATOR will be mostly assembled after unpacking.
However, once unpacked and standing up right, the drip tray will need to be inserted.
Location Requirements:
1.
Install in the area where it is protected from the elements including direct sun.
2.
Install and use only on a hard, flat and level surface.
3.
Do NOT place the dispenser inside an enclosed space or cabinet.
4.
Position the dispenser no closer than 4 inches from the wall with at
least 4 inches clearance on the sides to permit free airflow.
5.
Service should only be performed by a certified technician.
WATER COOLERS
•
It is very easy to replace 3 or 5 gallon coolers (not included).
NOTE: Excessive weight hazard - It is recommended to use two or more
people to move and install bottles. Failure to do so can result in injury.
•
WARNING: Do not use bottles with any cracks, leakage, or holes.
With reusable cap:
1.
If your water bottle has a reusable cap on the end
with a plug, safely place the 3 or 5 gallon bottle
onto the bottle probe and the nozzle should fit
securely onto the base. Once secure, you will begin
to see water flowing from the bottle to the tank.
If there is no reusable cap:
1.
Stand with your feet shoulder-width apart and
bend down to grab the new water bottle.
2.
Lift the bottle up and slowly tip it to a 45-degree angle
to allow water to begin dripping into the cooler.
3.
Place the bottle into an upright position as the flow of
water into the cooler begins to increase, and then secure it onto the base. Once
secure, you will begin to see water flowing from the bottle to the tank.
HOW TO OPERATE
7
Publicidad
