Lenco PDR-065 Manual Del Usuario página 14

Remote control transmitter
Battery installation (battery not provided)
The infra-red transmitter requires 2 pc AAA size battery for operation
Button description
Power on/Standby
Mode
Menu
- / +
ENTER
Preset
Preset Nr. 1 – 4
Volume up / down
BATTERY INSTALLATION
The battery compartment is located on the back of the remote control.
1. Remove the battery compartment door by pressing in on the tab and lifting it
off.
2. Insert two (2) AAA size batteries (not included) into the battery compartment
following the polarity markings inside the battery compartment.
3. Replace the battery compartment door.
BATTERY WARNING
1. Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
2. Use only the size and type of batteries specified.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
5. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries
can cause damage to the unit and may void the warranty.
6. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow
battery manufacturer's directions).
7. Do not dispose of batteries in fire, batteries may leak or explode.
Press to power on/standby the system
Press to select the function modes
Press to enter the menu setting
Press to choose the options
Press to confirm the setting
Press enter the FM/DAB radio preset station
To recall the peset FM / DAB station directly
Press to adjust the volume level
14