FanJu FJ3362G Manual página 5

Initial Operation
► Open the weather station battery compartment, insert 2 x AA batteries observing polarity [ "+" and " – " marks]
► When the power is connected all the icons on the LCD display will light up for 3 seconds, you will hear the buzzer,
and check the indoor temperature, humidity and pressure.
► Remove the battery compartment on the Wireless Remote Sensor, insert 2 x AA batteries observing the correct
polarity (+ and - marks) and close the battery compartment
► The Weather Station will now start to make a connection to the outdoor remote sensor. This operation takes about 3
minutes and is displayed by a flashing reception RF antenna symbol in the "
Wireless Sensor Transmission
► When the Weather Station successfully receives signals from the Wireless Sensor, the temperature and humidity of
the outdoor are displayed on the "
► The weather station can connect up to 3 channel wireless sensor registration. Touch the "
switch the display of different channels of outdoor temperature and humidity. When displaying the symbol "
cycle display channel 1,2 and 3 every 5 seconds.
► If the Weather Station failed to receive transmission from outdoor sensor ("--" display on the LCD), touch and hold
" " location for 3 seconds to receive transmission manually. The "
symbol，the Weather Station will re receive the wireless signal of the outdoor sensor.
Manual Time Setting
► Touch and hold down the "
operation beep. Touch "▲" and "▼" to set BEEP in ON or OFF.
► Touch " " to confirm your setting, switch to temperature unit setting. Now touch "▲" and "▼" to set the temperature
of the unit, the unit of temperature can be set to "°C" or "°F"
► Touch " " to confirm your setting, switch to pressure unit setting. Now touch "▲" and "▼" to set the pressure of the
unit, the unit of t pressure can be set to "hPa" or "inHg"
► Touch " " to confirm your setting, switch to daylight saving time (DST) function setting, Now touch "▲" and "▼" to
set the DST function to activate(ON) or close(OFF)
► Touch " " to confirm your setting, switch to the 12/24 hour mode display setting. Now touch "▲" and "▼" to set the
time displayed in 12-hour or 24-hour format
► Touch " " to confirm your setting, switch to the hour setting. Now touch "▲" and "▼" to set the correct hour.
► Touch " " to confirm your setting, switch to the minute setting. Now touch "▲" and "▼" to set the correct minute.
► Touch " " button to confirm your setting, switch to the year setting. Now touch "▲" and "▼"
year.
► Touch " " button to confirm your setting, switch to the month setting. Now touch "▲" and "▼" to set the correct
month.
► Touch " " button to confirm your setting, switch to the date setting. Now touch "▲" and "▼" to set the correct date.
FJ3362G Manual
" column of the weather station.
" location more than 2 seconds to enter the time and general settings, first set the
" display area on the receiver.
" the button can
" will show an animation of the RF antenna
", it will
to set the correct