www.morettispa.com
Model:
Voltage: 220-240 ~ 50Hz
Rated power input: 100W
IMPORTED AND DISTRIBUTED BY MORETTI S.P.A. Cavriglia (AR) Italy.
IT – USARE SOLO CON IL COMANDO SS03. UN'APPLICAZIONE PROLUNGATA CON REGOLAZIONE ELEVATA PUò
CAUSARE BRUCIATURE ALLA PELLE. NON UTILIZZARE CON INVALIDI, INFANTI E PERSONE INSENSIBILI AL CALORE.
NON UTILIZZARE SE BAGNATO.
EN – USED ONLY WITH DETACHABLE CONTROLLER SS03. A TOO LONG APPLICATION CAN RESULT IN SKIN BURNS. DO
NOT DRY CLEAN. DO NOT USE WITH INFANTS, A HELPLESS PERSON OR A PERSON INSENSITIVE TO HEAT. HAND WASH
ONLY. DO NOT USE IF WET.
FR – N'UTILISEZ LA COUVERTURE OU'AVEC L'INTERRUPTEUR TYPE SSO3. UNE APPLICATION PROLONGEE AVEC UNE
HAUTE TEMPERATURE PEUT CAUSERDES BRULURES A LA PEAU. NE PAS UTILISER AVEC LES INVALIDES, LES PETITS
ENFANTS ET LES PERSONNES INSENSIBLES A LA CHALEUR. NE PAS UTILISER S'IL EST HUMIDE.
ES – USE EL APARATO SOLO CON EL MANDO TIPO SSO3. UNA APLICACIÓN PROLONGADA CON REGULACIÓN ELEVADA
PUEDE CAUSAR QUEMADURAS EN LA PIEL. NO UTILICE CON PERSONAS INVÁLIDAS, NINOS Y PERSONAS
INSENSIBLES AL CALOR. NO UTILICE SI ESTÁ HÚMEDA.
PT – USAR SOMENTE COM O COMANDO TIPO SSO3. UMA APLICAÇÃO PROLONGADA COM REGULAÇÃO ELEVADA PODE
CAUSAR QUEIMADURAS À PELE. NÃO UTILIZAR COM INVÁLIDOS, CRIANÇAS E PESSOAS INSENSÍVEIS AO CALOR. NÃO
UTILIZAR SE HÚMIDO.
(Image for illustrative purpose only)
• Measure 40x30 cm (Cod. LTK700); Measure 63x42 cm (Cod. LTK710)
• Power 100W - Voltage 220-240V
• Material 100% polyester
10. TROUBLESHOOTING
ATTENTION!
If the electrical device does not work properly and it is defective, do not attempt
to repair it by yourself.
PROBLEM
POSSIBLE CAUSE
The device does not receive
the power source.
The device
does not
work.
Any temperature level
has been selected.
The temperature selector
is in position 0.
The protection against
overheating has been activated.
11. WARRANTY
MADE IN P.R.C.
SOLUTION
Verify if:
a. the power cable is connected
to the connecting socket;
b. the plug is insert in the socket;
c. the socket is defective;
d. the fuse of your mains
connection has been activated.
Move the temperature
selector to position 1, 2 or 3.
Have the device checked
by the manufacturer.
7