Aircare EVAPORATIVE MA0800 Manual Del Usuario página 6

ABOUT THE CODES
F – The F code means your unit is empty and needs to be FILLED with water.
CL – Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five seconds, until CL
appears. Your Mini-Console will lock on the current fan and humidity settings. Release the lock by pressing the power button again for five
seconds until the display flashes CL twice, letting you know the lock is off.
CF – The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and check your
wick. If your wick is still in good shape, simply clear the code by plugging your humidifier back in. If your wick needs replacing, follow these
quick steps:
1. Remove the water bottle and top from the base.
2. Replace your old wick with a new MAF2 Super Wick®. Wrap the wick through the base guides in a circle so the wick's ends meet.
3. Put the top and water bottle back on the base.
8
Plug in your unit and press the power
button power-of.
9
Set your desired fan speed by pressing
the fan button
has three fan speeds that are displayed by
F1 (the lowest speed) through F3 (the highest
speed). The additional AUTO setting (displayed
by an A) allows the fan speed to adjust
automatically to your humidity setting.
Note: On higher speeds, the Mini-Console puts out a tremendous
amount of humidity, so it's louder on these levels. Most of our
customers liken it to the sound of a box fan. Rest assured there is
nothing wrong with your unit, it's just working very hard to put out
much-needed humidity.
10
Press the humidity control button
set your humidity level from 25% to 65%.
The humidistat on your cord will read your home's
humidity and turn your fan off when the set level
is reached. When set to 65%, your unit will run
continuously.
That's it! Your Mini-Console is ready to use.
. Your Mini-Console
to