USE
ATTENTION! Do not use the appliance if the blades of the heads 3 and
4 (fig. A) are damaged or if the blade block is not working correctly.
Do not use the appliance on wet hair.
TURNING THE APPLIANCE ON AND OFF
Turning on
• Lubricate the head.
• Connect the plug to the socket.
• Press the switch in the 1 or ON position.
Turning off
• Press the switch in the 0 or OFF position.
• Do not pull the cord or the appliance to disconnect the power cord from the
mains socket.
USEFUL TIPS FOR CUTTING
• Wash the hair as usual, dry and brush it in the direction of growth to untangle
any knots.
• After drying, do not use hairspray, mousse or gel.
• Start with the larger comb and gradually reduce using lower size combs.
• For best results, use the appliance against the direction of hair growth.
• If hair starts to clog the guide comb, remove the guide comb from the appliance
(see par. "Removing the adjustable guide comb") and clean away the hair (blow
and/or brush out).
• Use the U-blade head 3 (fig. A1) to cut and finish.
• Use the T-blade head 4 (fig. A1) to cut and design.
USING THE APPLIANCE
Using without the guide comb.
When using the appliance without the guide comb, the blade of the
head (3, 4) will cut the hair very close to the skin.
The appliance can be used without the guide comb to cut hair very close to the skin
or to redefine the hairline of the neck and around the ears.
Use of the cutting guide combs
Turn off the appliance before changing or inserting any accessories.
To insert the guide comb (fig. A) follow the instructions below:
• Check that the appliance is off.
12