Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Using the unit
Always place the unit on a flat, dry and sturdy surface. Position the unit in a safe place to
prevent it from tipping over.
WARNING!
•
Before using the unit, always check that all parts have been properly aligned
and assembled to avoid any danger.
•
Do not let the power cable hang from the edges of a table or worktop. Make
sure the power cable cannot be pulled by children or animals, and does not
pose a tripping hazard.
•
Do not place the unit near a window where it could be exposed to rain.
•
Do not use the unit in a bathroom. Keep the unit away from all water sources
or very humid environments.
1.
Fully unwind the power cable and securely plug it into a suitable mains socket. Once
powered, the unit will beep and enter Standby mode.
2.
Press the
button on the fan or remote control to turn on the fan. The default speed
after connecting the unit is "1".
3.
Press the
/
4.
Press the
button to start or stop the automatic left-right air flow oscillation (85°).
To manually adjust the vertical tilt, press the
fan to stop completely, then gently push the fan head upwards or downwards to adjust
the vertical tilt angle (24°).
5.
See the "Control panel and remote control description" section above for more information.
NOTE: After a few seconds of inactivity (no buttons being pressed), the display will
turn off to save power whilst the fan continues to operate (speed, oscillation and
timer). Press any button (except
6.
When the fan is no longer in use, press the
unplug the power cable from the mains socket.
IMPORTANT: Always unplug the unit from the mains socket after use to fully
disconnect it from the power source.
button or
button to increase or decrease the speed (1-8) in a loop.
23
button first to stop the fan. Wait for the
) to turn the display back on again.
button to make it enter Standby mode and
EN
Publicidad
