American Standard 3749000.002 Instrucciones De Instalación página 3

FURNITURE INSTALLATION STEPS:
1. Assemble two drawer pulls to vanity using supplied M5 x 25 screw mounting kit 770251-100 or assemble towel bar to washstand using
supplied M8 x 25 screw mounting kit 770252-200 (Figure 1). Note that the drawer pulls and towel bar are required accessories that are
purchased separate from the furniture itself.
2. Prepare the wall to safely secure the furniture in place. Provide suitable reinforcement behind the finished wall. Centerline of
reinforcement should be 31" (787mm) from the floor (Figure 2).
3. Level furniture by adjusting each of the four 770253-200 leveling feet (Figure 3). Four leveling feet are included with the furniture purchase.
Drill at least two 3/8" (10mm) diameter anchoring holes through the centerline of the rear stringer of the furniture and attach furniture to
4. wall with wood screws not included with furniture. Per step 2 detail, the screws shall be inserted into suitable reinforcement within the
wall. Anchor the furniture to the wall through at least two of the anchoring holes in the rear of the furniture.
5. Install the Townsend sink top to the furniture. Refer to the appropriate sink installation instructions for sink details. Note that one of the
top options shown on the previous pages are required and are purchased separate from the furniture itself.
6. Apply a 1/8" (3mm) thick bead of water-based caulk around the top edge of the furniture (Figure 4) and place top on furniture. Refer to
the first page regarding caulk type. Allow caulk to dry before proceeding.
7. Purchase and install the appropriate faucet and drain according to the maufacturer's instructions.
FIGURE 1
Leveling foot 770253-200
FIGURE 3
RECOMMENDED CARE AND CLEANING OF AMERICAN STANDARD FURNITURE:
Clean the furniture and quartz tops using soft, slightly damp cloth. Buff the product by using a soft dry cloth.
1.
2. Avoid using silicone cleaners and waxes. Clean up excess water and spills immediately and use a blotting rather than a
wiping action. Water left over a long period of time will cause white spots in the finish.
NOTE: Some chemicals may damage the product finishes. Take care to avoid the following: iodine, hair dye, after shave
3.
lotion, shaving cream, alcohol, perfume, Lestoil
acetone, paint remover, Formula 409
Drawer pull kit 770251-100 (4 screws)
Towel bar kit 770252-100 (2 screws)
, Lysol Tub and Tile Cleaner
®
, Tile-X and Nair
® ®
Apply
sealant
FIGURE 4
, Lysol Spray Disinfectant
®
.
®
- 3 -
C/L of 2x6" or 2x4"
(51x152mm or 51x102mm)
Wood Reinforcement
31"
(787 mm)
Finished
Floor
FIGURE 2
Apply
sealant
, Dow Disinfectant
®
Apply
sealant
,
®
7 7 0 2 5 0 - 1 0 0