Publicidad
Idiomas disponibles
Idiomas disponibles
4
Call button
5
Speaker
6
Lens
7
LED indicator:
• Flashing blue light: the video doorbell is in setup mode.
• Red light on: there is a failure in the connection to the Wi Fi signal.
• Blue light on: the device is connected to the Wi Fi network.
8
PIR (infrared sensor): detects movement in front of the device to trigger
notifications.
9
Reset button: to reset the device, press and hold this button for 5 seconds.
10
Battery compartment: operates with 2 rechargeable batteries type
18650 (included)..
11
USB port: for recharging batteries via USB cable.
12
Holes for mounting bracket attachment.
13
Memory card slot. To locate it, the battery compartment cover must be
removed.
Wall mount
Mark the holes on the wall where the video doorbell is to be placed, using
the slots on the mounting bracket as a guide, then drill over the marks and
insert the anchors.
Attach the mounting bracket using the screws, then place the video door-
bell on the bracket by carefully sliding it from the top. Secure it to the
bracket by fastening the bottom part with two screws.
16
Publicidad
