Emos H4052 Manual De Instrucciones página 6

GB | IP Camera
Package contents:
Camera / Monitor / 2× power adapter / 2× USB cable / Mount / Screws / RESET pin / Manual
Technical specifications:
Power supply: DC 5 V/1 A
Camera dimensions: 150 × 80 × 80 mm
Monitor dimensions: 157 × 81 × 15 mm
Net weight: 462 g
Resolution: 2 304 × 1 296
Monitor battery capacity: 3 000 mAh
Sensor: 1/2.8'' 3 Megapixel CMOS
Description of the device: fig. 1
A – Status LED
LED flashing red: device waiting for connection to Wifi.
LED glowing blue: camera working correctly.
LED glowing red: device not working.
B – Microphone
C – Doorbell button/pairing button
Short press starts a call.
Long press activates pairing mode.
Desription of the device: fig. 2a
A – Microphone
B – Power supply status LED
LED glowing orange: Receiving power.
LED glowing green: Fully charged.
C – Status LED
LED glowing yellow: Monitor on.
LED off: Monitor off.
Description of the device: fig. 2b
A – Antenna
Changing the angle affects signal strength.
B – On/off button
Pressing and holding the button for 5 s turns the
monitor on/off.
C – Speaker
Installing the camera onto an even surface: fig. 3
Place the camera onto a clean, even surface.
Installing the camera on a wall: fig. 4
1. Place the enclosed mount onto the chosen spot.
2. Install it using the enclosed screws.
3. Install the camera onto the mount.
Installing the EMOS GoSmart app: fig. 5
The app is available for Android and iOS on Google play and App Store.
Download the application by scanning the corresponding QR code.
Router setting: fig. 6
The camera only supports 2.4 GHz Wifi (not 5 GHz).
EMOS GoSmart mobile app:
Fig. 5a
Open EMOS GoSmart and confirm the privacy policy by
tapping agree.
Fig. 5b
Choose sign up.
Fig. 5c
Enter a valid e-mail address and choose a password.
Confirm the privacy policy by tapping agree.
Choose log in.
Fig. 6a
Choose add device.
IR range: Night vision up to 10 m
Lens: 3.6 mm, F2.0
Storage: SD card (Max. 128 GB)
APP: EMOS GoSmart for Android and iOS
Connection: 2.4 GHz WIFI (IEEE802.11b/g/n)
Maximum number of users: 6
D – Night light
E – SD card slot
F – Speaker
G – Micro USB port
H – RESET button
D – Zoom controls
Capable of 1×/2×/4× zoom.
E – Enter menu
F – Controls – navigation in the menu
G – Confirmation button
H – Open call
I – Back button
D – Mount
E – SD card slot
F – RESET button
Pressing and holding RESET for 5 s resets the device to
factory settings.
G – Micro USB port
Fig. 6b
Choose the corresponding product category.
Fig. 6c
Choose the correct type of product.
Fig. 6d
Connect the device to power.
Fig. 6e
Make sure the LED on the device is flashing.
Confirm by tapping next.
Fig. 6f
Enter the name of the Wifi network and password.
Confirm by tapping next.
6