Worx WX852 Manual De Instrucciones página 12

is depressed.
1) Connect the clamp set to the
vehicle ignition port. Be sure
that the cable connection is
fully engaged and secure. Upon
connection, the clamp will
then light a flashing blue LED,
indicating the unit is in standby
mode. (See Figure B1)
2) Turn ignition off before making
vehicle connections.
3) Clamp the positive (red +) clamp
to the positive terminal on the
vehicle battery, and clamp the
negative (black –) clamp to
the negative terminal. Once
connected, the clamp will turn on
solid green. (See Figure B2)
Note: If you need to start more
than once, pay attention to the unit's
Status Display (at least 3 LEDs on).
If the unit lights on or beeps, check
the New Smart Cable Specification.
12
Note: You have 10 seconds to start the
vehicle (counting from the moment
the clamps are connected correctly
into the Jump Start) or the unit will
return to standby mode.
4) Start the vehicle (turn on the
vehicle ignition).
Note: If the vehicle doesn't start
within 6 seconds, let the jump starter
cool for 3 minutes before attempting
to start the vehicle again or you may
damage the jump starter.
Note: During very cold conditions,
the unit may not start on the first
attempt. We suggest attempting
to start a second or third time, as
the starting attempt will warm the
internal battery and improve your
starting chances. Do not attempt to
MULTI FUNCTION 4L JUMP
STARTER WITH LED LIGHTS
start after four attempts – either the
unit does not have sufficient power
to start the vehicle or there is a more
extensive problem with the vehicle
than simply a depleted battery.
5) When the vehicle is started, the
smart cable/clamp will show a solid
blue LED and the warning buzzer will
beep.
6) Disconnect the clamp from the
vehicle.
7) Disconnect the clamp from the
jump starter.
3. Charging mobile devices (see
figure C)
1) Plug the USB charging cable
into either the USB 1 or USB 2
charging port. You can charge up
to 2 devices at a time.
2) Connect the charging cable to the
mobile device
3) Press the power button to start
charging
4. Lighting
The jump starter features several
different work light modes through
pressing on the power button for
different times:
1. First Power Button press turns the
unit ON, indicating the unit's state
of charge.
2. Second press turns ON solid
working light.
3. Third press turns ON solid red
signal light.
4. Fourth press turns ON flashing
red signal light.
5. Fifth press turns ON solid
flashlight.
6. Sixth press turns ON flashing
flashlight.
EN