RDI RAILING AVALON ALUMINUM RAILING PRE-ASSEMBLED ALUMINUM RAILING SYSTEM Manual De Instrucciones página 3

LEVEL RAIL INSTRUCTIONS
WARNING: ALWAYS WEAR SAFETY GOGGLES!
TOOLS/MATERIALS NEEDED:
Safety goggles
Tape measure
Pencil
Level
Power screwdriver / drill
Power saw
Rubber mallet
Fully Assembled Panel
Level Bottom Mounting
Brackets & Bracket Covers
1.
Place rail panel across the opening and adjust
to ensure equal baluster spacing on each end
(Fig. 1). Mark the rail panel at the post face at all
four locations shown in Figure 1. Measure ¼" from
the marks towards the center of the panel (to allow
for bracket clearance, Fig. 2) and cut the panel at
this location on all four ends using a carbide tip
blade of at least 60 teeth.
COMPONENT LIST:
Description
1 Fully Assembled Panel
Level Top
2
Mounting Brackets
Level Bottom Mounting Brackets &
2
Bracket Covers
1 2-Piece Support Foot
18 Steel Panhead Screws
Level Top
Mounting Brackets
Steel Panhead Screw
2-Piece Support Foot
2
1
Fig. 1
Fig. 1
Fig. 2 Fig. 2
3 4
3