Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Temporarily assemble top and bottom level angle
brackets. (Bracket components are shown in
Figure 2.) Mounting brackets slide into bracket
base, bracket cover is aligned, and the bracket is
fastened together using the hinge bolt provided
(Fig. 4). Align panel on desired angle and mark
the top (Fig. 5) and bottom (Fig. 6) rails as shown.
Repeat this on the other side of the panel. Label
the top of the rail panel to simplify installation.
4.
For the bottom rail only, add ¾" (toward the rail
end or post, (Fig. 7) to the marks made on the
panel in Step 3 (Fig. 6) and cut the panel at these
marks. For the top rail, cut the panel directly on the
marks made in Step 3 (Fig. 5.) Remove the hinge
bolts from the brackets and remove the bottom
brackets from the bracket bases, and insert onto
bottom rails. Slide bracket into mounting bases
and set top rail onto the top rail brackets. Align
properly and test for fit.
5.
Measure the length of the rail panel and cut the
top rail (sold separately) to match. Press top rail
end covers into the top rail and place top rail
over the rail panel. Press down on the top rail to
ensure that it fits snugly onto the panel. Using the
holes in the bracket as a guide, predrill through
the railing using a
two 1½" painted pan-head screws up through
the holes locking the bracket, panel, and top rail
together. Once top rail is secured, tighten all four
of the hinge bolts to lock panel in place. Install
pyramid post top onto each post.
NOTE:
A rubber mallet may be needed for proper fit.
/
" bit as shown (Fig. 8). Drive
1
8
Fig. 4
Fig. 4
Fig. 5
Fig. 5
Fig. 6
Fig. 6
Fig. 7
Fig. 7
Fig. 8
Fig. 8
9
Publicidad
