RDI RAILING AVALON ALUMINUM RAILING PRE-ASSEMBLED ALUMINUM RAILING SYSTEM Manual De Instrucciones página 4

2.
Open the paper bracket mounting template
(included with brackets), align base trim with
appropriate guide on template, and secure
template in place using a piece of tape. Pre-drill
through the desired marked locations on the
template using a 1/8" drill bit. Remove template,
align brackets (Fig. 3) with the holes ensuring that
brackets are square, and fasten brackets in place
using the 1½" screws provided.
3.
Test fit the rail panel. Once proper fit is ensured,
press bottom bracket covers onto the ends of the
bottom rail (Fig. 4), and set panel in place. Pivot
support foot in place under the rail as shown
(Fig. 5).
Secure support foot to the mounting surface using
the 1½" screw(s) provided and press fit cover into
place using plastic plug(s) as shown (Fig. 6 & 7).
4.
Measure the length of the rail panel and cut the top
rail (sold separately) to same length. This should
match the cuts in Step 1. Press top rail end covers
onto the top rail and set in place on top of the
panel (Fig. 8). Press down on the top rail to ensure
that it fits snugly onto the panel and ensure that
top rail end covers are being held in place by the
mounting bracket.
4
Top Level Bracket Bottom Level Bracket
A.
B.
Fig. 3 Fig. 3
Fig. 4
Fig. 4
Fig. 5 Fig. 5
Fig. 6 Fig. 6
Fig. 7
Fig. 7
Fig. 8
Fig. 8