Publicidad
4. INSTALLATION STEPS
Assembled Light Fixture Mounting Point Measurements
2'x4' 3-Bar Fixture
4'x4' 6-Bar Fixture
IMPORTANT:
• Two persons are recommended for the mounting of light fixtures to ensure safety.
• Avoid touching the LED's while mounting the light fixtures.
IMPORTANTE:
• Se recomiendan dos personas para hacer el montaje de los dispositivos de iluminación para garantizar la seguridad.
• Evite tocar los LEDs mientras esta encajando y colocando los dispositivos de iluminación.
IMPORTANTE:
• Deux personnes sont recommandées pour le montage des luminaires afin d'assurer la sécurité.
• Évitez de toucher les DEL lors du montage des appareils d'éclairage.
Wire Hanger Mounting Instructions
Hang the top hook of 4 wire hangers to the rack shelf
1
frame or wire grid as shown. Space the width between
hangers at the minimum recommended spacing for the
fixture frame. Space the length between hangers at
approximately 42" (1066.8 mm).
2
With assistance from a second person, hook the bottom
of each hook through the slot on the fixture frame. The
hanger can be securely hooked through the screw hole
to prevent lateral movement, or it can be hook along the
slot if flexibility in spacing is needed.
Screw Hole Mounting Instructions
1
Drill pilot or through-holes in the mounting surface as
required according to the measurements provided.
With assistance from a second person, install #8 or #10
2
(M4 or M5) screws or other suitable hardware for the
mounting surface of the same size in each of the holes.
Tighten until the light fixture is secure and level.
2'x4' 4-Bar Fixture
4'x4' 8-Bar Fixture
1
2
13
Publicidad
