Publicidad
4. INSTALLATION STEPS
4.3 - STEP 3: INSTALL THE DC SPLITTER AND MANIFOLD CABLES
DC Splitter Cables
All DC splitter cables use a push-lock type M16 2-pin
connector to connect the cable to the light fixture LED
bars to a port on the DC manifold cables. The standard SKU
DC splitter cables are ordered in two styles, straight or right-
angle connectors. All operate the same way.
DC Manifold Cables
All DC manifold cables use an M16 2-pin connector to
connect the manifold cable port to the DC splitter cable.
Use a dust cap (p/n CDCG-71285-05) to cover all unused
manifold ports.
To Attach or Remove the Connectors:
To attach the connector, match up the keyed pins on
1
the cable (male to female) to the receptacle and push it
on until you hear a "click". Check that the connector is
securely attached.
2
To remove the connector, twist the ring on the base of
the connector counter-clockwise approximately a quarter
turn until it stops to release, and then pull straight out.
IMPORTANT:
• DO NOT plug in AC power BEFORE connecting the power supply to RAZR Modular light fixtures first.
• Install a dust cap on all unused DC manifold ports.
IMPORTANTE:
• NO conecte la alimentación de CA ANTES de conectar la fuente de alimentación a los dispositivos de iluminación RAZR Modular.
• Instale una tapa contra el polvo en todos los puertos del colector de CC que no se utilicen.
IMPORTANT:
• NE BRANCHEZ PAS le câble d'alimentation à une prise CA AVANT de brancher le cordon d'alimentation aux luminaires modulaires RAZR.
• Installez un capuchon anti-poussière sur tous les collecteurs CC inutilisés.
14
Straight Connector
1
2a
"CLICK"
Right-Angle Connector
2b
Publicidad
