Descargar Imprimir esta página

Adler europe AD 4128 Manual De Uso página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
the power socket, because water proximity presents risk, even if the device is turned off.
16. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
17. Do not touch the device with wet hands.
18. The device has to be turned off after every use.
19. Never leave the product connected to the power source without supervision. Even
when use is interrupted for a short time, turn it off from the network, unplug the power.
20. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
21. Before you turn on your device, make sure that all parts are installed correctly. Plug it
only with put on cover (8), well established security arm (11), properly installed feeder (2).
22. Before each use, check out the juicer filter. If you see any cracks or damage, do not
use the device.
23. Use the device only when the safety lock is closed.
24. Do not touch the blades of small mesh filter and stainless steel grater (9).
25. Use only accessories supplied by the manufacturer.
26. Do not remove the container to a pulp during the operation.
27. During operation, do not put your hands or any objects into feeder (2). To push fruits,
use only the pusher (1).
28. Fruits should be put into feeder during operation, you can not fill feeder with fruit or
vegetable at a standstill.
29. Be careful not to overload the juicer, do not use too much force to push products
through the filling hole (2).
30. Always unplug the appliance and disconnect the power cord from the unit when not in
use, or want to start cleaning it.
31. Do not disassemble the juicer if it is plugged into a power outlet.
32. Open safety lock after switching off the appliance and filter stops.
33. Do not immerse the motor part in water or any other liquid.
34. The device can not work longer than 3 minutes without interruption. After three
minutes, wait 20 minutes.
35. During the extrusion of thick juice juicers do not switch on more than 1 minute.
DESCRIPTION OF DEVICE
1. Pusher
3. Pulp container
5.3-position switch
7. Spout
9. Grater and filter sieve
11. Safety locking handle
BEFORE FIRST USE
1. Wash the parts of the unit, which will be in contact with food.
2. Feeder
4. Power cord
6. Base with motor
8. Cover
10. Juice and pulp separating bowl
12. Safety switch
4

Publicidad

loading