Western WRM15 dualB Manual Del Usuario página 15

WRM15 dualB is a device to charge up to two batteries from PV module that
powers and controls the load connected to its output. It is specially designed for
application on boat or camper where there are two batteries: the first one is for
feeding the on-board service and the other for starting the engine and engine
services. WRM15 dualB normally gives priority to the battery 1 (on-board
services) and then manages the battery 2 (starter). Battery 2 is still constantly
monitored and, if its voltage drops below a certain minimum voltage level, it
starts to charge.
To guarantee the charge of both batteries without running the engine both
during rest periods with passengers on board and during the parking period
without people on board, it is advisable to size properly the PV module
connected to the board system .
WRM15 dualB implements a charging circuit MPPT and step-down type, which
guarantees the maximum power charging from the PV module with any module
that has a maximum power voltage (Vmp) higher than the battery voltage and is
within maximum voltage limits (Voc) under 100V.
WRM15 dualB is monitored through an application installed on Android / iOS
smartphone that connects via Bluetooth® to the device and allows to visualize
the operating status and set some of its functionalities.
REV 1.2 19-01-2018
WRM15 dualB
User manual
PV CHARGE CONTROLLER FOR DUAL BATTERY
WRM15 dualB
 MPPT Technology (Maximum Power
Point Tracker).
 Dual battery management: Charging
priority to the primary battery and
then the secondary.
 Wide range of PV module voltage:
V max 100V
PAN
 Maximum PV module power: 250Wp
for batteries at 12V and 500Wp for
batteries at 24V.
 Suitable for: GEL, sealed, lead acid
and lithium-ion batteries.
 Charging voltage compensated in
temperature.
 12V / 24V battery voltage auto
detection
 18 load management programs
 Modbus on RS485 communication
port (provided by Western CO. WBUS
communication protocol)
 Remote control wireless
Bluetooth®and application
Android/iOS.
 USB port for the charge of the mobile
phone.
 Battery protection to prevent reverse
polarity.
 Low battery protection.
 Overtemperature protection.
 Overload protection.
 IP20
EN
1