Hymer 228000 Instrucciones De Uso página 8

1 Notes
1.1 This manual is valid only for products from the manufacturer. The products must not be mixed with
components from other manufacturers.
The technical details required for the assembly of dismantled products are provided in assembly
instructions or an assembly drawing. The assembly instructions/assembly drawing is included with
these products.
The commissioning engineer is responsible for ensuring that this user's manual is made available
to the users.
In addition to this, the avoidance of accidents in accordance with accident prevention regulations,
employers' liability insurance and operational specifications is the responsibility of the commission-
ing engineer.
1.5 The user's manual is complemented by one or more symbol stickers that are applied to the product.
These may not be removed, nor may their legibility be impaired by dirt etc. The instructions on the
symbol stickers shall be complied with.
2 Technical data
➢ See catalogue/assembly instructions/assembly drawing for stand-
ard dimensions.
➢ General tightening torque for bolts unless otherwise stated on as-
sembly instructions/assembly drawings:
Hammerhead bolts/hexagon head bolts:
M 8 = 15 Nm
➢ The hammerhead bolts shall be fitted offset by 90° (see
illustration right).
3 Testing
These products have been tested against the following standards/guidelines:
➢ DIN EN 131-1
➢ DIN EN 131-2
➢ DIN EN 131-7
4 General safety rules
The product may only be set-up and assembled by qualified persons. Once the product has been
set up, it shall be inspected and approved by a specialist.
This product may only be used for its intended use (see 6).
The provisions of the user's manual shall be observed without fail by all users of the product.
No liability is accepted for damage or personal injury caused by any of the following:
➢ Use contrary to the intended use
➢ Faulty assembly of the product
➢ Conversions or modifications to the product made by the user that have not been approved afore
in writing
➢ Overloading
➢ Use despite visible damage
➢ Failure to observe the instructions for use, accident prevention regulations or standards and di-
rectives applicable at the location of use
➢ External influences
Warning notices shall be affixed to projecting parts of the product or on adjacent structural elements
that could cause accidents.
0095690 | 03-2023
EN
M8 = 15 Nm
Figure:
Hammerhead bolt in a profile
8 | 29