Troubleshooting; Warranty And Liability; Scope Of Delivery - EGAmaster 79902 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

When working on or with the equipment, it is imperative to observe all legal requirements in regards to waste-
disposal and proper recycling. In particular during installation, repair and maintenance work, water damaging agents,
such as:
· lubricating grease and oil,
· coolant,
· solvent containing cleaning agents must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in suitable containers!
The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Machine does not start
Machine is rotating too
slowly
Machine makes strong
noise
Other trouble
We ask you to send the machine to the supplier, if necessary.
To guarantee the performance of the machine it is necessary to compensate the pressure under water.
For every 10 meters of depth it is necessary to add one bar pressure to the compressor with respect to the
indicated.
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims in regards to persons
or equipment damages are invalid, if one or more of the following causes apply:
Improper use of the machine,
improper assembly, startup, operation or maintenance of the machine,
operation of the machine with defect safety devices or improperly fixed or non-functioning safety and
protection devices,
not considering of the instructions in the operating instruction booklet concerning transport, storage,
assembly, startup, operation, maintenance and setting up of the machine,
independent structural alterations or settings on the machine beyond the intended purpose,
inadequate supervision of wear parts,
improperly carried out repairs, inspections or maintenance,
catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our control.
Check, if the scope of delivery is complete:
1 Operation and maintenance manual,
1 Pneumatic Impact Wrench, Accessories, if applicable.
ENVIRONMENTAL REGULATIONS

TROUBLESHOOTING

Cause
Not connected to pneumatic supply.
Too little operating pressure
Hose diameter too small
Too little volume flow
-
-

WARRANTY AND LIABILITY

SCOPE OF DELIVERY

Remedy
Connect and open the neumatic line
Increase operating pressure
Choose larger hose diameter
Increase volume flow
Contact authorized expert company
Contact authorized expert company
33

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

79903

Tabla de contenido