engelmann HCA e2 Manual De Instrucciones página 21

- Product scale is selected (optional): The entered radiator output in watts is displayed (e. g. 750W):
- The check sum for the current consumption has been selected (optional): These appear on the display loop
directly after the current consumption (example):
- If the algorithm in the standard 2-sensor operation mode detects accumulated heat, the device switches to
temporary 1-sensor mode. This is displayed as "1F HEAt" (please see also 8).
- If the HCA e2 is in storage mode / delivery mode and the ambient temperature drops below 0 °C then
"COLd" is displayed.
- If the HCA e2 is opened after mounting on the radiator but within the mounting time frame (waiting
period), appears "OPEN" (please see also 9).
- If the HCA e2 is opened outside the mounting time frame (waiting period), appears "OPEN C" (C = Contact)
in the display cycle. Here, it is assumed that there is a manipulation of the HCA e2 (please see also 9.2).
- If a reset of the manipulation detection (OPEN C) is performed, the display shows "STBY" (STBY = Stand by)
(please see also 9).
- If the Engelmann heating cost allocator HCA e2 is in the tenth year of operation, this information is indicated
in the display as "ANNO 10". Analogously, "ANNO 11" is displayed in the eleventh year of operation.
Page 21 of 59 Article no.: 5081200002 2022_10_31 Subject to technical change! Errors excepted.