Descargar Imprimir esta página

Porsche Mini LED Lamp Manual De Instrucciones página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Original operating instructions
Never touch a device that is connected to the mains with wet
DE
2
hands, or if it has fallen into water. In this case, rst switch o
EN
the house circuit breaker and then pull out the mains plug.
Do not expose to potentially explosive environments where
2
there are ammable liquids, dusts or gases.
ES
Never submerge the product in water or other liquids.
2
Do not kink the connection cable, do not pull it or taut it or
FR
2
allow it to come into contact with sharp objects, chemicals or
solvents.
IT
Use only an easily accessible mains socket so that the
2
product can be quickly disconnected from the mains in the
NL
event of a fault.
All illuminated objects must be at least 10 cm away from the
SE
2
lamp.
Use the product exclusively with the accessories included
PT
2
with it.
Never try to open, crush or heat a standard/rechargeable
RU
2
battery or set it on re. Do not throw into a re.
The product may only be charged in closed, dry and spacious
KR
2
rooms, away from combustible materials and liquids.
Disregard can result in burns and res.
CN
Leaking battery uid can cause irritation if it comes into
2
contact with the skin. Immediately rinse a ected areas with
JP
fresh water and then seek medical attention.
Do not short-circuit connection terminals or batteries.
AR
2
11
WARNING
DANGER OF FIRE AND EXPLOSION
Do not use while still in the packaging.
2
Do not cover the product - risk of re.
2
Never expose the product to extreme conditions, such as
2
extreme heat/cold etc.
Do not use in the rain or in damp areas.
2
CAUTION
GENERAL NOTE
Do not throw or drop it.
2
The LED cover cannot be replaced. If the cover is damaged,
2
the product must be disposed of.
The LED light source cannot be replaced. If the LED has
2
reached the end of its service life, the complete lamp must
be replaced.
Do not open or modify the product! Repair work shall only be
2
carried out by the manufacturer or by a service technician
appointed by the manufacturer or by a similarly quali ed
person.
Disconnect the device from the power supply only by pulling
2
on the plug or plug housing, never on the cable.
Information for the light and mains adapter as well as mains
2
voltage on the socket must match with the type plate.
The lamp shall not be placed face-down or allowed to topple
2
face-down.
Mini LED lamp

Publicidad

loading