Sentry Fire-Safe GF Serie Manual De Instrucciones página 5

Electronic lock instructions
Your new Sentry ® Gun Safe is equipped with one of two electronic lock options, Standard or UL Type 1. Instructions for
operation of each type of lock appear on the following pages.
The sticker on the back cover of this manual contains the serial number and factory code for your safe. It is important that
you keep this Owner's Manual in a secure place, other than in your safe, for future reference.
Standard electronic lock
To activate lock
Four alkaline AA batteries, Voltage: 6Vdc, (not included)
are required to activate the combination keypad.
NOTE: Non-alkaline and rechargeable batteries
ARE NOT RECOMMENDED.
To install batteries:
1. Using two hands, hold the combination keypad, thumbs
down, on its left and right sides. Push up the keypad with
your thumbs, and disconnect it from the safe by pulling
it towards you. (Fig. A)
2. Let the disengaged keypad hang by its wires. This will
expose the battery holder. (Fig. B)
3. Install four alkaline AA batteries as illustrated on the
back of the battery holder.
4. Reconnect the combination keypad by inserting the
keypad's four posts into the matching holes.
5. Push down to snap into place.
A
B
Using the keypad on electronic safes
Liquids can damage the keypad!
Pen points or other sharp objects can puncture
the keypad membrane!
Battery
Holder
Caution!
Caution!
Test first with door open!
(See back cover of this manual
for your factory code.)
Test your factory code several times with the door open.
NOTE: Only a light touch is needed. A green
PROCEED light and a single beep indicate
that the keypad "felt" your touch. The lock
allows 5 seconds for each key press. If you
pause longer, an error signal will occur
(blinking red light and three beeps),
indicating you should start over.
1. Press the five-digit factory code. The green light will
come on.
2. Open the door.
Access codes
There are three possible ways to unlock and access the
safe—by entering its preset Factory Code, your own User
Code or a User PIN (Personal Identification Number).
You can always open the safe by entering the 5-digit Factory
Code. This code cannot be deleted. But if you prefer to
use your own code, you can program the safe to open to the
5-digit User Code of your choice. If you wish to give some-
one else temporary access to the safe, you can program a
User PIN that can later be erased.
Programming a user code
There are two ways to program a user code.
A 1. Press the Program key. (Prog.)
2. Enter the Factory Code. The green LED remains ON
while you enter the 5-digit user code of your choice.
After 5 digits are entered the green LED turns OFF.
(To enter a new User Code, repeat these steps.)
B 1. Press the red button on inside of door (hinge side).
The lock will "beep" and the green LED will come on.
2. Enter a 5-digit user code.
(To enter a new User Code, repeat these steps.)
Keep your new
user code secure
For your records, please copy it here:
_______ _______ _______ _______ _______
5
®