Publicidad
Idiomas disponibles
Idiomas disponibles
Digital Stand Fan Instructions
ON/Speed button
Press the ON/SPEED button (on the remote control or on the control panel) to switch on the fan. At first operation
it will start at medium speed; for following operations, the fan will start at the last selected settings.
Press the ON/SPEED button again to select HIGH or LOW speed.
Off button
Press the OFF button to switch off the fan.
Mode (only on remote control)
Press the MODE button to change the operating mode:
Normal: the fan operates at a constant speed. The mode indicator is off.
Nature: the fan simulates a natural breeze mode by automatically alternating fan speeds, as in nature. The NAT
mode indicator is green.
Sleep: the fan simulates a soft, natural breeze suitable for night-time use. The SLP mode indicator is green.
Swing
Press the SWING button to activate the oscillation function for widespread breeze distribution.
Press the button again to stop oscillation.
Lamp (only on remote control)
Press the LAMP button on the remote control to turn off all indicators on control panel, when the fan is off but still
plugged to the wall socket (stand-by mode). This option cannot be selected when the fan is on.
Timer
Push the TIMER button (when the fan is working) to set the time in which the fan will shut off (the led indicators
corresponding to the time set will appear on control panel). Timer can be set to a maximum of 7,5 hours; by
pressing the button, the rime is set half hour by half hour, and the green LED indicators corresponding to the set
time will turn on.
Adjusting tilt of the fan head
The fan head can be tilted so that the breeze is directed towards a precise angle.
To tilt the fan head, make sure the fan is disconnected from the power supply.
Hold the motor housing of the fan with one hand, and grip the fan head with the other. Carefully tilt the fan head
until it reaches the desired angle.
Caution: Do not attempt to tilt the fan head further than it is intended to. Doing so will damage the
unit.
Cleaning
Before performing any cleaning operation, switch off and unplug the fan.
For cleaning the fan, use a soft cloth, that can be slightly damp.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not spray water or other liquids on the fan in order to protect it.
After cleaning, dry every component before using the appliance.
During the winter season and when not in use for a long time, keep the appliance in a dry and clean place.
Technical data
Power : 50W
Adapter : 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
11
EN
Publicidad
