Putting Into Operation; Connecting The Mf Control En - Abicor Binzel MF Control Manual De Instrucciones

6 Putting into operation

6 Putting into operation
6.1 Connecting the MF Control
The MF Control must only be used in conjunction with the eBOX MFS-V3 master feeder system.
NOTICE
• Please take note of the following instructions:
• The system must only be put into operation by qualified personnel (in Germany, see TRBS 1203).
Pin assignment for
M12 plug
Carry out each step in accordance with the figure below:
Fig. 3
EN - 8
 5.2 Control elements on page EN-7
Assignment (Ethernet, power supply), 8-pin, A-coded,
view from side of pin
1
2
3
4
5
6
7
8
A
B
Connecting the MF Control
RX+
RX−
TX+
24 VDC+
24 VDC+
TX−
24 VDC−
24 VDC−
MF Control