HUANUO HNCM8 Instrucciones De Instalación página 3

Step 1
Install the Pole to the Desktop
Option A: Weighted Base Installation
1.Attach Rubble Foot (t) to the Weighted Base (b),
see Figure 1.
2.Install the Pole（a）to the Weighted Base(b) by
using M6x10 Bolt(e). Connect Bolt(k) and Washer(l)
to the pole from the bottom of the weighed base.
Tighten the Bolt(k) with Allen Key(n). Insert the
Decorative Cover(s) to the Pole(a). See Figure 2.
Option B: Grommet Base Installation
Existing Grommet Hole Installation
1.Attach Soft Pad (u) to the Pole (a), see Figure 3.
2.Position the Pole(a) on the mounting surface and insert Spring Washer(j), M10
Washer(i) and Support Plate(h) to the M10 Bolt(g). Use provided Wrench(o) to fasten
the M10 Bolt to the Pole. Insert the Decorative Cover(s) to the Pole(a). See Figure 4.
Figure 3
Figure 1
u
j
t
s
h
i
g
o
2
a
s
n
table top thickness:
0-80mm(0-3.15in.)
e
b
l
k
Figure 2
Figure 4