Publicidad
STEP 1
1. Place top board (1) upside down on soft padded surface.
2. Attach back cross bar (7) to top board (1) by inserting 3 screws (C) through holes on back
cross bar (7) and tighten to top board (1).
3. Repeat above step to attach front cross bar (8) to top board (1).
STEP 2
1. Attach 1 side frame (2) to top board (1) by inserting 2 screws (B) through holes on side
frame (2), then tighten to back cross bar (7) and front cross bar (8) using Allen wrench (I).
When tightening, slightly push screw in to catch inner thread.
Publicidad
