Makita HR2445 Manual De Instrucciones página 6

Side handle (auxiliary handle)
4
1
2
3 6
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
1
2
Insert the bit into the tool. Turn the bit and push it in until
it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
001295
1. Grip base
5
2. Side grip
3. Loosen
4. Teeth
5. Protrusion
6. Tighten
001296
1. Bit shank
2. Bit grease
001297
1. Bit
2. Chuck cover
2
1
Bit angle
(when chipping, scaling or demolishing)
For Model HR2455 only
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
the bit is securely held in place by turning it slightly.
Depth gauge
1
The depth gauge is convenient for drilling holes of uni-
form depth. Loosen the side grip and insert the depth
6
001298
1. Bit
2. Chuck cover
2
003576
1. Lock button
2. Action mode
changing knob
1 2
symbol. Then make sure that
003577
003865
1. Depth gauge