Publicidad
Step 17
1
D87
K
Groove
Insert the DRAWER SIDES (D87 and D88) at an angle
å
into the slot at each end of the DRAWER FRONT (K).
3
M63
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M63) to the DRAWER
å
FRONT (K). Tighten one HIDDEN CAM.
Page 22
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
Hidden part using
recycled material.
Color may vary.
K
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D729) into the
å
grooves in the DRAWER SIDES (D87 and D88)
and DRAWER FRONT (K).
4
D87
M63
Fasten the DRAWER BACK (D61) to the DRAWER
å
SIDES (D87 and D88) and DRAWER BRACE (M63).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
427307
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D729
D87
K
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(5 used in this step)
D61
D88
www.sauder.com/service
9
D88
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Publicidad
