Descargar Imprimir esta página

LIVARNO home 898-S-2 Instrucciones De Uso Y De Seguridad página 56

Ocultar thumbs Ver también para 898-S-2:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
remove the rubber cap.
Please note: the cap cannot be screwed on
in this position and hangs loosely on the
cable. This has no effect on the functioning
of the product.
Mounting the solar panel on a wall/
roof
Screw the solar panel screw fixing
the solar panel/spotlight bracket
the connecting sleeve
hand-tight (see Fig. A).
Use the fixing holes
wall bracket
to mark the positions for
19
drilling the holes (see Fig. G).
Drill the holes (dia. 6 mm).
Now insert the wall plugs
holes
(see Fig. F).
20
Offer the wall bracket
mounting surface and fix it in place with
the screws
(see Fig. F).
23
Now push the solar panel/spotlight bracket
onto the solar panel wall bracket
4
until it very lightly snaps into place.
Now connect the plug of cable
socket of cable
18
plug of cable
to the charging socket
18
of the LED solar spotlight.
Now align the LED solar spotlight as
desired.
Please note: to detach the bracket again,
very carefully press the tabs on the sides of
the guide rail
until the bracket can be
5
removed.
Mounting the solar panel on the
ground spike
Screw the solar panel screw fixing
the connecting sleeve
hand-tight.
Now join the LED solar spotlight
together with the ground spike
the connecting sleeve
spike into the ground (lawn, soil, etc.)
where desired.
56
GB/IE/NI/CY/MT
onto
3
using
4
and tighten it
2
in the solar panel
20
into the fixing
23
up to the
19
19
to the
6
and then connect the
onto
3
and tighten it
2
11
using
17
and push the
2
Please note: make sure the solar panel is
attached firmly!
Now connect the plug of cable
socket of cable
plug of cable
of the LED solar spotlight.
The spotlight and solar panel are now ready
for use.
RISK OF INJURY! Make sure you remove
the ground spike when removing the
spotlight to avoid any risk of injury (e.g. trip
hazard).
z Charging the battery
The battery is charged regardless of the
position of the switch. To optimise initial
charging, charge the LED solar spotlight
while it is turned off.
Please note: the battery is fully charged after
it has been well exposed to sunlight for 6 to 8
hours. The duration of the charging process
depends on the battery's charge level and the
quality of the sunlight.
15
z Positioning the solar panel
Orientation
The optimum alignment is facing south. It is
better to face the solar panel slightly to the
west than slightly to the east.
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
not dirty.
Now align the solar panel
position using the screw fixing
A).
z Operating the LED solar
spotlight
Please note: Only operate the floodlight
6
and then connect the
18
to the charging socket
18
and fix it in
1
(see Fig.
3
to the
15
is
1

Publicidad

loading

Este manual también es adecuado para:

898-w-2