HOMCOM YH-20-3 Instrucciones De Montaje página 3

Location of Controls
1. Thermostat control knob ( TEMPERATURE SETTING)- Adjust to maintain room temperature.
2. Flame switch - Switches flame effect and power on/off.
3. Heating setting: please press "
4. Heating setting : please press "
first press " ")
5. Flame dimmer control - Adjust to set flame intensity.
Lay stove upside down on a padded surface to avoid scratches to the surface of your stove.
Line up holes in the leg with holes in the underside of the stove body. With the use of the
screwdriver secure leg with the screws provided (3 screws per leg) as shown in the figure below.
Overheating safety device
If the heater stops working, turn it off and check if the inlet or outlet is blocked. Unplug the unit and
wait at least 10 minutes, so the protection system can reset. If the heater still does not work,
contact customer service for inspection or repair.
Before restarting the heater, ensure it has been unplugged for at least 10 minutes.
Cleaning
1. Always unplug the unit before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum or any other detergent or chemical solvent to clean the heater.
4. When the heater has not been used for a while, store in a clean, dry place, away from dust and dirt.
Environmental Protection
Waste electrical production should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority or retailer for recycling advice.
" for 750W.
" and " " at the same time for 1500W (can not operate without
3
WARNING: Do not use this heater with
missing, damaged, or broken legs.