Defrosting - Selecta TEMPLOW L 2101280 Manual De Instrucciones

INSTRUCTIONS MANUAL
Reading the temperature progression
Press . Display =
Scroll through the list using
Period in hours in which the maximum and minimum interior
temperatures were measured
Maximum (highest) measured temperature
Lowest measured temperature
Select the required item using the
again to return to the list.
You can exit the menu at any time by pressing
If no button is pressed within 60 seconds, the electronic control
system switches back automatically.
Resetting the alarm events
Press . Display =
Press + for 5 seconds. Display =
Press for 5 seconds. The electronic control system will switch
back to normal operating mode.
Resetting the recorded temperature progres-
sion rt
Press . Display =
Press . Display = -
Press for 5 seconds. Display =
The values for and
temperature) are then reset to the current interior temperature.
Press for 5 seconds. The electronic control system will switch
back to normal operating mode.
Resetting the parameters to factory settings
The alarm limits and sensor calibration values can be reset to the
factory settings using this function.
Pull out the mains plug.
Keep pressed and connect the mains plug.
Display =
Press . Display =
The electronic control system will switch back to normal operat-
ing mode.
18
J
.P. SELECTA s.a.u.
CODE 80170
or .
button. Press this button
for 5 seconds.
.
.
(highest and lowest measured interior
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
REV D
Storing
The grid shelves can be moved
to accommodate different
height bottles or packages.
(1) The ventilation slots on the
inside must not be covered!
(2) Stacking mark
Only load the top shelf up to the stacking mark. This is impor-
tant so as to ensure that the air can circulate properly and the
temperature is even throughout the interior.
NOTICE
Store raw meat or fish in clean sealed containers on the bottom
shelf of the refrigerator/freezer compartment so that it cannot
come into contact with any other food or drip liquid onto it.
A failure to follow these instructions may result in the food being
spoilt.

10. DEFROSTING

Defrosting
The refrigerator compartment defrosts automatically.
Activating the defrost function manually
If the door has been left slightly open for a long time, a layer of
ice may form in the interior and on the cooling plate. The defrost
function can then be activated manually.
Press for 3 seconds. Display =
The electronic control system will automatically switch back to
normal operating mode.
Display =
Setting the display indication for the defrost
phase
Press for 5 seconds. Display =
Press until appears in the display.
Press . Display =
Use button or to select the desired setting.
0 = Symbol + alternating display of
perature in the interior of the appliance.
1 = Symbol + temperature before the start of the defrost phase.
2 = Symbol + .
Press . Display =
Press for 5 seconds. The electronic control system will switch
back to normal operating mode.
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
07/2020 Pag. 18
+
and the current tem-