Hensel KX 0202 C Instrucciones De Montaje página 17

Disposal
In case of malfunction or at going out of use dismantle the equipment
and make it unusable.
Dispose of the equipment in compliance with locally valid
environmental protection regulations.
Material information:
- bottom part, lid, lid fasteners, external brackets: Polycarbonate
- lid gasket: Thermoplastic Elastomere (TPE)
Safety
Danger caused by electric current
WARNING! Electric current!
Danger of electric shock when performing installation work.
Please be particularly:
- Deenergize electric power lines to be branched before starting
installation work and secure them properly against being switched
on again. Observe safety rules for safe work on electrical
installation!
- The location intended for installation must be free of concealed
electric power lines in the wall or under wall cladding.
- For installation work use only tools which are generally approved for
this type of work.
32
Conduct in case of danger and accidents
In case of an equipment defect there is a risk of electric shock and
explosion.
- Deenergize the system immediately and secure it against being
switched on again.
- Perform trouble shooting and rectify the fault.
- Before restarting the electrical system replace the faulty equipment.
Unpacking
Take the equipment out of its packaging material and check the
contents for completeness.
Dispose of the packaging material in compliance with locally valid
environmental regulations.
In case of transport damage or incompleteness consult the dealer
immediately.
Conformity with standards and directives
- DIN EN 60079-0:2019-09
- DIN EN IEC 60079-0:2019-09
- DIN EN IEC 60079-7/A1:2018-07 - Low voltage directive
- DIN EN 60670-1:2014-01
- DIN EN 60079-31:2014-12
- DIN EN 60670-22:2007-07
- Directive 2014/34/EU
2014/35/EU
33