Cramer 82T20 Manual De Instrucciones página 4

EN
1 DESCRIPTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2 OVERVIEW
Figure 1 - 19.
Battery release button
1
Trigger
2
Lock-out lever
3
Speed switch
4
Carrying ring
5
Auxiliary handle
6
Shaft
7
Trimmer head
8
Guard
9
Brush cutter blade
10
Lower clamp
11
Cut-off blade
12
Tab
13
Spool cover
14
Spool
15
Slot
16
Hole
17
Metal rod
18
Angle transmission hole
19
Nut
20
Wrench
21
Gear box
22
Spacer
23
Outer cup
24
Nut
25
Wrench
26
Direction of rotation
A
Best cutting area
B
Dangerous cutting area
C
2 GENERAL SAFETY
WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this machine. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
WARNING
English
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
Remove the battery pack from the machine before
installation.
Do not use accessories that are not recommended for this
machine.
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
For your personal safety, do not insert battery before the
tool is assembled completely.
3.2 ATTACH THE GUARD
Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the guard with the supplied hex
wrench.
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
4
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING