Set Up Of The Agc System - Midland BTX2 PRO Manual De Instrucciones

1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on perma-
nently.
3. Now press the Middle button for 3 seconds. The Blue and Red light will flash.
4. Do the same procedure on the other unit. When successfully paired, each unit will have
the Blue light on for one second and then go back to the setup mode (Red light always
on).
5. Now the pairing procedure is complete, you just need to exit the setup mode before
you can use the units.
6. Double click on the Middle button, the Red light will turn off and the Blue light will start
flashing.
You can use now your Midland BTX2 PRO
Attention: remember to switch off all the other Bluetooth device that are not part of the pairing
procedure, only the two devices involved in the pairing must be turned on.
How to use the Intercom with two units
To use the intercom feature, be sure that both units are turned on and correctly paired
together.
Manual activation
Press the Middle button on one of the two units in "Intercom" mode. Communication is
enabled and remains active until you press again the middle button. The intercom need
some seconds to activate, you will hear a beep tone when the intercom is open.
Voice activation (VOX)
Simply say something, after some seconds the communication will be opened and will
remain active for the time you are talking. If there is no conversation the intercom will be
closed after 40 seconds. If needed you can close the intercom manually without waiting
40 seconds (just press the middle button).
If needed, you can disable the VOX feature simply by pressing the Backward button for
7 sec. A voice announcement will advise you when the VOX is disabled. To turn the VOX
on again, just press the same button and a voice announcement will advise you that the
VOX is now active. This setting is remembered also if you turn off the unit.
Attention: The Voice activation (VOX) can open the intercom communication only to the unit
www.midlandeurope.com
that was paired with the Middle button. If you choose to use a different button (Forward or
Backward ), you will be able to active the intercom only manually.
Adjusting the volume
Your Midland BTX2 PRO uses AGC technology, which automatically adjusts the liste-
ning volume in relation to background noises.
However, it is also possible to manually adjust the volume by means of the "Volume +"
and "Volume -"buttons. The volume setting is indipendent for each audio source:
intercom, stereo music, phone call, FM radio.
Attention: volume can be adjusted only when an audio connection is active.

Set up of the AGC system,

To adjust the sensitivity of the AGC system you can use the "BT UPDATER" Pc Softwa-
re or the smartphone "BT SET-APP" application. You can choose different set up based
on your motorbike type (naked, touring, sport) or if you are riding as a passenger. You can
disable the AGC system pressing "Volume +" and "Volume -" togheter for 3 sec.
25