Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL
elde
2
1
CONNECTIONS AND OPERATING ELEMENTS
1. INPUT 1 / INPUT 2
Audio input with 6.3 mm jack socket.
A. Connect an instrument using a shielded instrument cable.
B. Connect the speaker output of a guitar amplifier using a speaker cable.
(Tip: Press PAD switch no. 4).
WARNING:
WARNING:
input and output must be disconnected (switch no. 6 in the non-pressed LIFT position).
WARNING:
ATTENTION:
To prevent damage to the amplifier, before switching on the amplifier, an appropriate guitar speaker
or a suitable load resistor at the THRU jack socket must be connected using a speaker cable.
2. THRU 1 / THRU 2
The input signals are output unchanged via the 6.3 mm jack sockets.
3. OUTPUT 1 / OUTPUT 2
Balanced audio outputs with male 3-pin XLR connectors. Use a balanced, shielded cable (e.g. microphone cable)
to connect the DI box to balanced inputs of a mixing console or audio interface.
4. PAD 1 / PAD 2 (Passive Attenuation Device)
Move the corresponding switch to the pressed position to lower the level of the output signal by 30 dB. Lowering
the output level is necessary if the channel input stage of the connected mixer or audio interface is overdriven.
EN
1
2
Power amplifiers must not be operated in bridge mode on the DI box.
If an amplifier is operated using the DI box, the ground connection between the
The amplifier power of a connected amplifier must not exceed 120 W at 8 Ohms.
When using a tube amplifier: there is no tube in the circuit of the DI box circuit!
2-Channel DI Box
passive
3
4
5
4
5
3
12
Publicidad
