Palmer elde Manual De Usuario página 13

USER MANUAL
5. LIFT / GND 1 - LIFT / GND 2
Switch for disconnecting the ground connection of input and output of the corresponding channel (ground lift).
In the non-pressed position, the ground connection is disconnected; the connection is established when the
switch is pressed. The ability to prevent a humming loop using the ground lift switch depends on the grounding
of the connected device. It is therefore possible that the switch is able to effectively reduce or eliminate humming
when it is either up or down, depending on circumstances.
CAUTION:
input channel (mixing console, audio interface, etc.), as well as the THRU output, are muted when
plugged in. Otherwise, noise levels may cause damage.
NOTE: Strong magnetic fields can cause humming. Therefore, do not position the DI Box near strong magnetic
fields (e.g. mains transformer).
WIRING EXAMPLES
STEREO FX / AMP SIMULATION
STEREO FX / AMP SIMULATION
STEREO FX / AMP SIMULATION
EN
Connecting signal cables can cause considerable noise. Please make sure that the
INPUT 1
INPUT 1
INPUT 1
INPUT 2
INPUT 2
INPUT 2
INPUT 1
INPUT 1
INPUT 1
INPUT 2
INPUT 2
INPUT 2
INPUT 1
INPUT 1
INPUT 1
INPUT 2
INPUT 2
INPUT 2
BALANCED OUTPUT 1
BALANCED OUTPUT 1
BALANCED OUTPUT 1
BALANCED OUTPUT 2
BALANCED OUTPUT 2
BALANCED OUTPUT 2
BALANCED OUTPUT 1
BALANCED OUTPUT 1
BALANCED OUTPUT 1
BALANCED OUTPUT 2
BALANCED OUTPUT 2
BALANCED OUTPUT 2
BALANCED OUTPUT 1
BALANCED OUTPUT 1
BALANCED OUTPUT 1
BALANCED OUTPUT 2
BALANCED OUTPUT 2
BALANCED OUTPUT 2
L R
L R
L R
13