Publicidad
Idiomas disponibles
Idiomas disponibles
and keep it pressed.
f.
With the allen wrench(9), tighten the clamping bolt(13)turning in rota- tion direction.
Install the Rip Guide
To install the rip guide on the machine, perform the following steps.
a.
Unplug your circular saw.
b.
Insert the rip guide (7) through all three slots on the base plate (3) at the front of the saw,
starting with slot in the left side edge of the base.
c.
Slide the left guide (7) through the slots until it extends out the right side of the base plate(3).
d.
Adjust the rip guide for the desired width of cut and then securely tighten the rip guide locking screw (12).
Install the Vacuum Adaptor Hose
a.
Connect the small end of the vacuum adap- tor (8)
to the dust extraction port (5) on the tool.
b.
Connect the other end of the vacuum adap-
tor(8) to the end of a vacuum hose.
WARNING:Observe correct main voltage! The voltage of the power source must agree with
the voltage specified on the nameplate of the ma- chine.
Switch On/Off
Before engage the ON/OFF switch (15), check that the saw blade is prop- erly fitted and run
smoothly, the blade clamp bolt is well tightened.
To start the machine, press the ON/OFF switch (15) and keep it pressed. To stop the machine,
release the ON/OFF switch (15) or when it is locked with the lock-off button (14), briefly press the
ON/OFF switch (15) and then release it.
Laser Function
WARNING:Do not stare directly at the laser beam, do not deliberately aim the beam at
person- nel and ensure that it is not directed towards the eye of a person for longer than 0.25s.
When you make the line of the cut on the work piece, the laser can help you get better alignment.
a.
Make sure line of the cut on the work piece.
b.
Adjust the angle of cut as required
c.
Plug in the machine and start the motor
d.
When the blade is at its maximum speed (approximately 2
seconds), place the saw on the work-piece.
e.
Switch on the laser from the laser aperture using the laser
switch (21).
f.
Align the beam with the mark on the work-piece and slowly
push the saw forward using both hands, keeping the red light
beam on the mark.
Switch off the laser beam when completed the cut.
OPERATION
- 06 -
Publicidad
