Publicidad
I. Safety Instructions
Before installing, operating or maintaining this product, it is important to read and ensure that the contents
of the following Quick Installation Guide are fully understood. Failure to follow all the specified instructions
and procedures, will invalidate the warranty and as such Solplanet will not be liable for any claims for
compensation.
• Do not open the EV charger under load or when it is not electrically isolated.
• Do not use the EV charger if it is damaged.
• Do not extend the charging cable with an extension lead.
• Do not touch or insert foreign objects into the charger socket or the cable plug.
• Do not install the charger near flammable, explosive, or combustible materials.
• All work on the equipment must only be carried out by qualified personnel who have read and
fully understood all safety information and installation requirements contained in this guide.
• The EV charger must be out of reach from children.
• The EV charger must be connected to a protective earth conductor.
• The electrical installation must comply with all applicable local safety requirements, standards and
guidelines.
• No modifications, not limited to mechanical or electrical, must be made to the EV charger.
• Components should not be changed or replaced by the end-user or unqualified personnel.
II. Mounting Environment
• Danger to life due to fire or explosion.
• Despite careful construction, if installed incorrectly or mounted in unsuitable locations, electrical
devices can cause fires. This can result in death or serious injury.
• Do not mount the EV charger in areas containing highly flammable materials or gases.
• Do not mount the EV charger in potentially explosive atmospheres.
Requirements for mounting location:
• Please avoid exposing the EV charger to direct sunlight.
• The surface for mounting of the EV charger must be made of a non-flammable material.
• It is recommended that the location offer protection against rain, running water or other liquids.
• The location must offer sufficient air ventilation.
• The installation surface area requires at least 230 mm x 360 mm.
ENGLISH
1
Publicidad
