Publicidad
Removing the top cover
1. Remove all eight screws from enclosure, no need to
take out anti drop screws from top cover(B).
2. Remove the top cover (B) (Take care with the cable
which connect to the top cover on the socket version
of the EV charger) .
5
V. AC connection
• All electrical installations must be done in accordance with all local and national rules.
• Ensure that all power sources have been electrically isolated before any electrical
terminations have been made.
Installing the incoming AC supply cable
There are two options for installing the incoming AC supply cable.
Option 1
Through the cable gland (A) located on the bottom
of the enclosure.
4
Installing the inner screw on the
bottom cover
1. Thread the screw (A) through the sealing rubber
(B) located at the sealing rubber accessory. Then
install the mounting screw (A) to secure the
enclosure to the surface. The recommended torque
is 4.4 Nm.
6
Option 2
Drilling a hole through the rubber seal located on
the rear of the enclosure (A).
ENGLISH
Publicidad
